The only white wire that corresponds to pump 2 is the one on the bottom. The first top wire is for the spa lights, the next two for the ozonator, next is the black one for the blower, Next 3 is for pump 1 and the bottom wire is for pump 2. There is an additional slot for pump 2 if there were a black, red, and white. I tried swapping the blower motor wire and the pump wire hoping to get the pump to work but no success. The only way that I can get the pump to run is putting the white pump 2 wire on the white pump 1 white wire, and I think that shuts off pump 1. The fuse is also good because I can run pump 2 off pump 1 white wire and I have tested the fuse. Lastly the wire that's from the pump goes directly into the circuit board so I don't think it could be a receptacle mistake.