OK So I have read through this forum and the last few days, I have always had issues with my tub so now I bought the Taylor kit and started fresh last night. Here is what I have now.
400 Gal tub
TA 50
PH 7.8
CH 220
My problem is when ever I run the pumps with the air my PH will go over 8.0, I let the tub sit over night and my readings this AM were
TA 50
PH 7.6
CH 220
This was before I ran the pumps at all, after running the pumps my PH went back to the 7.8 8.0 range.
Should I read the PH before I run the pumps and go with that reading or after the pumps have run?
My temp is up to 102 but I have not added any Bromine yet so I have not tested for that. Waiting to get the other numbers right first.