johnybarkerr

According to me, I am confused on the lights problem, looking at the board there is no cable plugged into the slot marked "Lights". I do have a cable plugged into a box marked "fiber optics" I also have a seperate box to the right where the wire runs too, I think the box has gone bad and that what causes it to trip.

Guy is Who Moved my bathtub, use 1 "Schedule 40 PVC conduit. They have a short length of about 30 and rolled over bathtub, they singled out because they are behind and on the front, theyagain and they moved to Hot Springs is about 150 feet, and more gravel and cement.

I have also checked the jumpers to make sure the jumpers are correct. Could the board be bad? Do you have to buy the whole control box, or just the board. I also found a place to repair boards.

According to me, All pumps need to be primed. Some are better self-primers than others, and jogging the pumps to prime, as PFC5 notes his controller does, will work although I believe it's very tough on the equipment. If you get an airlock (bubble) at the pump inlet it won't pump, and this is why it will need priming. You just need to get the air bubble out.