NC Pool

5 and 6 (water) are connected correctly, I went and rechecked. (Also my indoor unit scrolls the water temp.) The indoor control has several buttons and it can be programmed to manage the pool.

My computer skills are similar to my pool skills, hopefully this works: The reason that im trying to get this air sensor working is that I plan on keeping my pool open all winter. I do not plan on using it, but I was told that in the end it is the easiest thing to do with a pool. We get plenty of cold weather here and freezing temperatures but the pool is pretty to look at. Do you have an opinion on this. http://s1084.photobucket.com/albums/j418/pbkohler/ Thanks

cid:1318C92C-59F6-4465-9AFE-C8FB9CBB17D8/photo.JPG cid:D95CB51A-5B7C-430D-AF39-82198D12B903/photo.JPG cid:926A0C66-2BE9-468F-A469-8CFE8C7CB1C5/photo.JPG I have attached 3 pictures: Inside panel box door showing where to tie in wires A full view of the panel box where all of the wires are connected A close up view of the receiver where I plugged in the air sensor ( 8 & 7 ) and also shows the two disconnected wires slots ( 3 & 4 ) labeled solar sensor. Isis wire them in and the results did not change. FYI: The wire that carries the two disconnected wires are part of a four wire grouping, two of those wires are wired into slots 2 & 1 I hope that the pictures help and thank you for your help.

Help please: indoor display says that "air sensor shorted" also says "solar sensor shorted" I replaced the sensor with a new air/water/solar sensor, I am still getting the same message on the display. I simply attached the two wire into the slots as noted on the display panel guide. I noted that the solar wires are not connected inside the control panel...truthfully not sure if there is a solar anything on my pool. I did push the reset, but still got the same message. Thanks-