mzzzellie

I've decided to call a local spa repair dealer and have them come take a look. (Ann Arbor is just a bit too far, or I would have called you!) Hopefully with your advice and info, it will make the job easier for them. Thanks so much.

What year is the jetsetter? If it's an older model from the early 2000's and older it may be a nipple that cracked. If it's a 2003 or up it's probably the elbow behind where the air line connects. You would need to pull those boards off with a small pry bar. Start from the bottom of the board and work your way up. Thanks for the quick response. I will have to check and make sure, but I believe we bought it new in 2005. How are those boards attached, with some type of glue?

Today,finally a nice day in Michigan and I set out to get our hottub ready for use after a long, cold winter. As I usually do, I had dewinterized it according to the manual. I started putting water in, and it becan to leak out the backside, the side that has the moto-massager. I found this forum and thought I'd start here. How do you get inside that part to look to see if a piece of pvc or piping needs to be replaced? I removed the four screws on the main door and can't see that area from there. Thanks.