I spoke with Goldline tech support and they stated that because of my unsuccessful attempt to change the Product name back to AL-0, that I need to by a new board (GLX-PCB-RITE). Can anyone confirm before I throw out a couple hundred bucks?
Thanks
I have an inground pool with an Aqua Rite chlorine generator and T-15 cell (note that cell was recently inspected at nearby pool dealer and "passed").
Here are the stats shown on the control panel:
Salt level: 3000 (NOTE: our pool store measured our water and said the salt was really 3300 ppm)
Pool temp: 77
Cell voltage: 31.9
Cell current: 0.00
Desired output: 99p
Instant salinity: -0
Product name: AL-5 (?? I do not have a separate controller and have tried to change this to AL-0 per user manual)
Software revision: r1.33
The only LED that is on is the "Power" light. No other LED's are on. Note that I have tried to toggle the Auto/SuperChlorinate switch to set AL-5 to AL-0 without any response (per other forum discussions). I've also visually inspected the controller board and did not see anything unusual.
Please help!