JandySaltUser

A few days ago when I last tested the CYA was 30-50 and the pool temp was 75 degrees. I starting boosting today because I need chlorine in the pool so I can't try your test yet of setting the production rate to 100%. I know it works when I boost so I know the cell works. It's got to be something between the handheld and the board when using the production rate. I'll try your test after boosting.

I've taken my pool water to be tested for chlorine and it's always at 0 only a few days after Boosting the pool or adding shock. It's almost like the cell isn't generating chlorine unless I set it to Boost. I'm hoping someone can help. -There's enough salt, and other chemical readings are fine -No error codes on the Aqua Pure -Flow light is on, so I know water is flowing I did notice that on the panel it reads 00% for the production rate. But on my Jandy Handheld it reads 60% which is what I set it to. Not sure if this is normal? Any advice would be much appreciated. Technical support from Jandy told me to have a technician look at it.