Hello - I have a Jandy Aqualink with 2 issues: 1) the pool water temp is always above 100 degrees F, even in dead of winter - but I don't get any type of error message. 2) this morning I noticed the filter and cleaner were still running 2 hrs after scheduled finish time. Date/time settings and program settings are still intact, and there has been no power outage. The troubleshooting guide says to check the battery, and/or to clear the programs and reset. I turned the cleaner off at the controller this AM, and it shut off both the cleaner and the filter. About 2 hrs later, they both turned on again.
Any thoughts or suggestions?
thank you, Mike