Hi,
I just replaced the heater relay on my hydroquip cs300. Stupid me did not label or write down the locations of the six leads that came off of it.
I know the main power in was at the L1 position.
There is a lead (10ga.) straight to one heater element post. another to the in line fuse. A third to the main contact.
Two smaller gauge wires piggy backed, one to the pressure switch, one to the heater on light.
Another piggy back that goes to the side of the main contact relay and to the motor connection.
I'm not sure which combination goes where.
I tried it the way I thought the wires were, I didn't get a miswired light. The pump came on when I dialed up the Tstat, and the heater light came on. However after 12 hours no heat.
Any ideas? Does anyone have a schematic for this box?
Thanks
Paul