PeterM

Hi - I have a an aquarite pool chlorinator and Basically the only time lights come on is on restart - Flow blinks for about a minute; then when that goes out the Green Generator light comes on for about 10 seconds and turns off. The power light does not turn on, nor do any other lights. The diagnostic readings are as follows: Im not sure if the titles are correct, but based on what the previous writer mentioned they line up: Salt level: 3100 (NOTE: our pool store measured our water and said the salt was 0 ppm - I added chlorine as my pool is turning green) Pool temp: 85 Cell voltage: 3.9 Cell current: 0.00 Desired output: 100p Instant salinity: -0 Product name: AL-0 Software revision: r1.13 I've been through 1 new cell a few years ago... when I went to clean the one that's in there now, it looked almost new. - no build up at all... but cleaned it anyway - still no generation... Any help is appreciated. Thanks!

Hi - I saw the below quote, and I have a similar problem... but I haven't bought any parts yet. Basically the only time lights come on is on restart - Flow blinks for about a minute; then when that goes out the Green Generator light comes on for about 10 seconds and turns off. The power light does not turn on, nor do any other lights. The diagnostic readings are as follows: Im not sure if the titles are correct, but based on what the previous writer mentioned they line up: Salt level: 3100 (NOTE: our pool store measured our water and said the salt was 0 ppm - I added chlorine as my pool is turning green) Pool temp: 85 Cell voltage: 3.9 Cell current: 0.00 Desired output: 100p Instant salinity: -0 Product name: AL-0 Software revision: r1.13 Any help is appreciated. Thanks!