Search the Community
Showing results for tags 'beachcomber 160 / digital 1000'.
-
I'm completely new to this forum and to forums in general but it seems there are a lot of people on here with a lot of experience so I'm hoping someone can help... We moved into a new home which has a Beachcomber 160 / Digital 1000 management system hot tub that was installed in 2002/2003. It was working when we first moved in but over time there have been a few problems - OH errors, leaking knife valve, FL errors etc so it has been sitting unused for 18 months. We've recently managed to replace the valve and fix the leak and refilled the hot tub. When we power it on it goes through a set up where the display panel shows '21' then '03' then displays the temperature and after a couple of seconds shows a constant 'FL' code. The pump does not activate. We turned it off at the mains and back on again. This time , it went through the ‘21’, ‘03’ Etc and When it showed the Temperature on the display we pressed the on/off (function switch) on the control panel and the pump started up?? Conclusion is that the Low speed pump only comes on if manually pressed before the ‘FL’ errors shows. So it’s working but with some fault. Our concern is that when it reaches temperature it turns off. Then when it is supposed to come on for the cleaning cycle it does not automatically come on. Pump does not come on automatically. We have had the flow switch (paddle type) tested and it works so we assumed it was the capacitor - we have now replaced this and it is the same problem. We're really not sure what else to try? Any suggestions?