JohnP

Can I plug it and use the other 5?

Is there a easy way to fix a broken threaded pipe part that the hex jet attaches to. Like an adapter or jet that mounts directly to the wall. Thanks in advance.

I have low pressure coming out of my Sta-Rite heater I think. The filter is clean and pressure is good on the filter. The water is still going into the hot tub and heating, but just not enough water pressure is going through. Could it be cracked heater coils or could a bad manifold bypass valve cause this. I am also not loosing any water, so I don't think it is cracked pipes underground. Thanks in advance

Yes, it is the 400 HD. Thanks

I was not getting any fault display. It would say 180 then r6 and then turn off and go blank with no fault display (on the front also no service codes on the back would light up). I took out the control unit and moved the ribbon attached to the membrane around while pressing spa on and it fired up. I can only control it now by moving the ribbon around back and forth, the ribbon has a kink in it pinching the connections. I am wondering if there is a jumper on the control unit or a way to jump the ignition on without the membrane until I get a new one. The pump is on a timer to filter the water and I don't want to leave the heater on. Just want to turn the heat on when I go in.

Hello, My control board is out on my Sta-rite heater. Is there a way to bypass the control board and membrane to fire up the heater? Thanks in advance.