MGR38

I have a 2004 Sundance Altimar 850 series. I just installed a new board. I noticed the jumpers in different spots on the new board. My question is can someone tell me what jumpers should be in what numbers(for the P9 & P19 spots)?? This would be a REALLY big help!!!!! Thanks

Well I was able to fix the problem. There is a "T" fitting after the flow switch. I flushed the tub a few weeks ago & all was good. I think since then some small pieces of scale broke free off the heater & got stuck in this "T" & greatly slowed the water flow. I unclamped the two large hoses going into the "T" & flushed it out. Put the clamps back on & poof.......like new again. I still wish I could find out what type of screw is in the center of the footwell covers. I dont think those filters have ever been cleaned.

I will check it when I get home tonight. The filters are new. I did take the filter out but didnt stop flashing FLO. I read in the manual the the footwell filters should be cleaned every two months. For all I know they may never have been cleaned. If they are plugged wont that affect the flo a lot??? From what I can tell nothing is coming out of the heat well return. Heater wont run do to the FLO error so its hard to tell. I will look at the switch tonight. When I turn both pumps on high only one foot well intake is really sucking in water. One other one sucks very little & one feels like its not sucking in anything. Thats what made me want to take the foot well covers off to clean those filters. :(

Well after looking at the covers more it looks like a screw is in the middle of them holding them on. I tried small & big screw drivers(both styles) & nothing would grip on. I cant make out the head style under water. Anyone know what style screw or bolt they would use. I hate to drain the tub over this but its driving me crazy.

I have a 2004 Sundance Altimar that came up with the FLO error. We have only had the tub a few months so I have no idea the last time the footwell intake filters were changed or cleaned. I want to take the covers off to clean them but I have no clue how to take them off. Twist, pull, no matter what I do no luck. I dont want to break anything & I feel this is what is causing the FLO error. How do I get the covers off???? Please help!!!