aland1905

Using calcium hypochlorite to disinfect water is a good idea. However, rather than trying to dump some amount of pool shock chlorine into a tank and hoping that it dissolves and mixes with the water, a better idea is to mix a slurry of it in a plastic bucket (it will corrode a metal one) and pour and mix the slurry. Also, the halide (halogen, chlorine or iodine ions) need to be in contact with the water for some amount of time before they can kill all the bacteria - and that time is dependent on the temperature of the water. Colder water takes longer. To test the degree of halogenation in water, 642-456 I suggest that people get a pool water test kit and use it. They are very inexpensive, and easy to use: Simply get a (clean) bucket of water that's been treated, and use the pool water test kit (for halogenation), ideal 'pool water' is about 2 parts per million (ppm) chlorine, drinking water should be between 2 and 5 ppm when treated - the chlorine will gas off over time, as long as the water isn't likely to be re-contaminated (in an open top tank, for example) it doesn't really need to be retreated. Dump the 'test' water out, [orthotolidine] OTO isn't too good to drink. 646-363 The test kit will have directions but basically you put the test water into a clear chamber, add a reagent--usually orthotolidine (OTO)--to the chamber, and compare the color to the provided chart. If the water tests too low, add more slurry, if too high, next time don't add so much. People will be able to figure out the approximate 'right' amount pretty quickly. 650-180 The military chlorination kits (for Lister bags and water buffalos) suggest as much as 10 ppm. This is to allow for high levels of organic material in the water (which adsorbs the chlorine, keeping it from disinfecting the water, and allowing the water to not be retreated too quickly); you probably recall drinking beverages so treated with as much fondness as I do. - Flighter