Roninpilot

Pool Clown to the rescue again. If you worked in S. Texas I'd hire you all day. Thank you

I came home today, my Aqualink RS6 says pump is off but when I went outside my main pump is running! I checked the power panel it was still in Auto mode. If I select Service mode, the pump remains on. When I select Time Out Mode the pump remains on but the light flashes. I tried resetting the system at the power panel (outside) nothing changed. The only way I can turn my pump off is by turning off the breaker switch on the power panel. Please Help Thanks

Hey Pool Clown, your reply reminded me of an earlier post I made in June that you replied to. The symptoms were different, but I isolated the spa side remote like you had recommended the last time and it took care of the problem. Not sure how it was enabled to begin with but again, thanks for taking the time. Take care

Hello all, I apologize if this has been asked before. I looked but could not find the answer. I have a Jandy RS6 that recently started commanding equipment off and on randomly. My sheer descent comes on and off, the hot tub turns on, then the heater all without any input from me. I have cleared the memory, I've reset the control panel and I've removed complete power (including 9V backup) and nothing seems to have fixed it. Any help/guidance would be greatly appreciated. Thanks in advance

I will give it a try Thanks again!

pooltech9, I misspoke. It's an AquaLink not Aquarite. Thanks for identifying my error. Pool Clown, You sir are a genious. I disabled the spa side remote and everthing is working great. You just saved me some serious cash. I guess I would need to replace the spa side remote for future use? Thanks a million

I apologize if this has been asked before, I searched but could not find the answer. I have a Jandy Aquarite RS6 panel part # 6888. Just yesterday for no apparent reason it switched to filter pump and spa on. No matter what buttons I push it will not come out of this mode. I attempted to reset but it continued with the same problem. I isolated it to service mode and everything is working fine as long as I'm not using the indoor panel. I ran a diagnostic and it indicated: 8157 REV JJ I would greatly appreciate any help. Thanks in advance