gnbrian

Here goes my first experience. I have aquired a Vita L200 Bijou 110v with l200 Disc tech contoller. Just got electric hooked up today. Spa runs, I set time. In program mode I can cycle to heat mode but when I press prog 3 times will not get to filter cycle time. At some point while trying to go thru sequence the GCFI (20 amp) trips. I would assume there is some type of excessive draw or short? Can anything thing in the controller cause this? I am really new to all this and need to do some fooling around with it but need a basic starting point. In a single 110v pump application are the pumps 2 speed? Does heater run at same time as pump?" If not could that cause the GCFI trip?Thnak you. I am sure I left out important details

I don't think the entire jet body needs to be replaced, but I cannot see how to reover the internal,if there really is one. Are some jets actually just a simple port with an eyeball directional fitting? I could show in pictures, but cannot post here?

I am new to the hot tub world and have alot to learn. On my new aquired Vita Bijou there are 2 jets right in the back of the knee location on the lounger. The bezel on both of these jets has come off and I think they are broken since I don't see a way to reattach. How are they attached or how do I remove the entire jet so I can replace. Thanks in advance

Does anyone have any experience with CLI Crystal Stone pebble finish?