dc1955

Hi there, having a swimming pool for 20 years and now a spa that gets a lot of use by adults and children, I have found if the water balance is where it should be then a good cleaning of the filter would clear the water up

on a tiger spa 110 volt system all the relays that control the heater and the jet pump are low voltage so how is the 110 voltage that goes to the jet pump and heater transferred to the mother board?

hi all new member here we have a 2004 tiger spa bengal model m 110 volt system on our spa the heater relay board and mother board burn't up like so many others. we purchased both boards new and installed them,push the jet button and it worked! so we shut off the jets and let the heater do its thing. when the water temp was at the set limit we pushed the jet button and are experiencing the same issuse as the original post.after checking all of the connections i am at a loss. any ideas? thanks