So to who ever had read my last post I did get that fixed and added the solution on that post,
Now have a new issue, when we got the circulator put going we bled the l lines but guess we did it in the wrong spot, we bled the line right at the ciculator pump. So when we turned the hot tub on everything was looking good I had my hand on the heater tube and it was getting hot quick so we disconnected it about 30 secs after powering it on. There was flow coming thru but did not like how it heated up so I bled the line right by the heater tube and there was air in the line and I heard the water sizzle on the heater element. I spoke to balboa about this and the support tech told me that should not be anything to worry about it should be fine. so we made sure everything was bled and powered the hot tub back on and everything is working fine great flow through the circulator pump all jet pumps work and the heater light is lite up.
But after running all night it did not heat, are those heater elements that sensitive could they burn up that quick or should I check something else out before replacing it?
As always thank you for all your responses