Jump to content

OH and HL error code


Recommended Posts

Started up hot tub after a bit of time with it off, started off fine - filled and heated.

then the HL error code displayed suggesting temp was over 48 degrees but it is actually 30 degrees

I have tried off/On, clear filter etc and now when I start it shows the OH error code which again is for high temp then after a while of running goes back to HL.

Tub is a Wellis Jupiter, anyone had similar and have any advice? 
 

thanks 

Link to comment
Share on other sites

What control system is in the spa. Post photos of the circuit board and the schematic on the inside cover.

Likely going to be temp sensor. Sometimes on start up if you can be watching the topside when the spa is powered up and it has gone through the PR mode you can watch it "run away". It will start at the actual temp then increase up to the HL temp and throw the error code.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...