Jump to content

Heater and blower came on *after* I shut down spa


THALL

Recommended Posts

 Pentair/Sta-rite 400.  I had heating problems with the spa, replaced the thermistor and high heat sensor, and just for fun the thermostat (now it leaks of course), but just when I thought I had some success and shut the whole thing off, the heater and blower came back on--even though jets were properly off.  Went ahead and ordered a new pad because the LED readout was nearly useless and buttons seem inoperative as well for setting temps.  I threw the breakers and turned off the gas.

 Thoughts?  TIA!

 

 P.S. The system is apparently so old that I can't the right sized pleated filters for the filter housing, so I'm doubly PO'ed.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...