Campfire Posted July 24, 2022 Report Share Posted July 24, 2022 Had to replace jets on a 2013 Jetsetter. Cut the old tube and now I need to find the best way to attach a new 3/4 flex pvc tube to the old one. Problem is some of the old tubing does not create a friction fit only a loose fit. Will Christy's Red Hot Blue Glue join these two successfully? Or do I need a brab to brab adaptor? Trying to stay with the coupling instead of a brab since it won't restrict flow. https://youtu.be/xsVhdvqYZ74 Quote Link to comment Share on other sites More sharing options...
Spa Shop Rotorua Posted July 31, 2022 Report Share Posted July 31, 2022 A coupling should do the job fine. Ensure it’s clean and use a decent pipe cement. To be extra safe you could use some 2 part glue over each of the coupling joins… barb to barb adaptors are also fine 1 Quote Link to comment Share on other sites More sharing options...
Campfire Posted August 1, 2022 Author Report Share Posted August 1, 2022 On 7/31/2022 at 3:06 AM, Spa Shop Rotorua said: A coupling should do the job fine. Ensure it’s clean and use a decent pipe cement. To be extra safe you could use some 2 part glue over each of the coupling joins… barb to barb adaptors are also fine Thank you. It worked out perfectly. One last question. While dremeling out one of the old jets, the cutoff disk must have slightly touched the shell and now there is a very small less than a 1/4 inch crack in the shell by the jet. What is the best method to patch this up? Here is a video of the leak. https://youtu.be/iTib0pEr5O0 Quote Link to comment Share on other sites More sharing options...
Spa Shop Rotorua Posted August 13, 2022 Report Share Posted August 13, 2022 Use a 2 part epoxy or similar on the back side and it should be fine… I don’t generally like poking around with glue on the inside shell Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.