the mighty Q Posted July 7, 2022 Author Report Share Posted July 7, 2022 9 minutes ago, RDspaguy said: So you did that? I thought it might have been whoever told the previous owner it needed a board. Nope, I have to take some of the credit. The previous told me it needed a new “program board” and showed me this picture that I will upload here. So I had a guy come install it he charged me an arm and a leg. The seal in the back of the heater had a crack in it so it was leaking water out of the back of it so I ordered and installed another one. I only installed the wires for the new heater. The breakers where constantly tripping due the incorrect wiring on my part. Attached below is the original board that came with the spa that the original Kerner said I needed to replace. Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted July 8, 2022 Report Share Posted July 8, 2022 So you replaced the whole pack? I thought you just did the relay board, as those are a common problem. That's why they are on a separate board. Quote Link to comment Share on other sites More sharing options...
the mighty Q Posted July 8, 2022 Author Report Share Posted July 8, 2022 5 hours ago, the mighty Q said: Lol yes very inexperienced. Just bought my first home and the jacuzzi came with. Lol Ok so I did what you said and the heater light does come on now Quote Link to comment Share on other sites More sharing options...
the mighty Q Posted July 8, 2022 Author Report Share Posted July 8, 2022 3 hours ago, RDspaguy said: So you replaced the whole pack? I thought you just did the relay board, as those are a common problem. That's why they are on a separate board. So I was not supossed to do that? Quote Link to comment Share on other sites More sharing options...
the mighty Q Posted July 8, 2022 Author Report Share Posted July 8, 2022 On 7/6/2022 at 6:47 PM, the mighty Q said: 13 hours ago, RDspaguy said: So you did that? I thought it might have been whoever told the previous owner it needed a board. Ok so I switched the black wires for the bower and the circ pump added a jumper to the pressure switch and started it up. When I first turned on The breaker A red light came on for the heater indicator light. Then water began to flow from the outlet hose from the heater for a brief minute then it stopped. The jets worked and but the heater did not continue work. I have tk pick up a voltage meter today to text the fuse. I will be send more photos so you have a better idea of what’s going on. Thank you Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted July 10, 2022 Report Share Posted July 10, 2022 On the circuit board are some led lights labeled htr on, lim ok, and control unplugged. Which of these are lit? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.