RF_Burns Posted May 30, 2022 Report Share Posted May 30, 2022 Hello, I have a Gecko in.yj-3 controller that appears to be just cycling ON/OFF and not powering up. I opened the controller and checked the power voltage all ok... 240V and 120V to neutral. The Power LED on the board just cycles On/OFF in about a 1 second cycle, along with 3 other LEDs on the board. I can also hear a relay clicking at the same rate but I can't identify which relay. I had just filled the hot tub yesterday for the season and got the water PH etc levels set today. When I looked at it later this afternoon the display was flashing and no operation. Anyone have any ideas? I have a disappointed wife.... Thanks for any suggestions. Quote Link to comment Share on other sites More sharing options...
RF_Burns Posted June 1, 2022 Author Report Share Posted June 1, 2022 Well, I actually had some time left under warranty and the dealer did an over-the-counter exchange! You don't get that service often these days! 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.