DeeDee Posted March 21, 2022 Report Share Posted March 21, 2022 Hello, We had a new fiberglass pool put in the ground in October/November time frame. The pool was filled about two thirds of the way up. Now after rain, snow melting, etc. the water is up to the water line tile line. We can see the pool is not level. The ends are level looking to each other however the sides of the pool where the curves are on both sides are about three to four inches higher than the ends. What would cause that? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.