Awall82 Posted January 17, 2022 Report Share Posted January 17, 2022 My Gecko in.k1000 controller is stuck in an initializing boot up loop. From searching online all indications are it's the low voltage board. A few questions related to it. The low voltage board is in the spa pack, not the controller? Correct? What are my options, seems I have a few that vary by price, what is the easiest? Unfortunately here in Edmonton the weather currently is heading for overnight lows of -24°C. 1. Replace Entire Spa Pack ~$750 2. Replace the Spa Pack Low Voltage Board ~ $620 3. From another thread found on this site. Replace the 5600 UF 25V capacitor mentioned here by @Sebast for much less. Is failure of the 5600 UF the common cause of failure on the boards or is other troubleshooting needed? Thanks for any assistance. Quote Link to comment Share on other sites More sharing options...
cranbiz Posted January 18, 2022 Report Share Posted January 18, 2022 Post up pictures of the board. A bad capacitor is usually pretty obvious to those of us who know electronics. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.