ugotabkdin Posted October 27, 2021 Report Share Posted October 27, 2021 I want to put a 7x7 hot tub in corner of my yard, but have a problem: The 7x7 footprint will protrude about 6" onto the already-existing pool deck, which (obviously) is slightly sloped away from the pool. Do I need to cut out a part of that deck to accommodate the full square pad, or would it be okay to just make the pad level with the existing deck, with the one corner of it consisting of the existing deck? See photo. Quote Link to comment Share on other sites More sharing options...
JimboCh Posted October 28, 2021 Report Share Posted October 28, 2021 So when it rains the water that hits the pool deck is going to run down under the hot tub . Is that how you want it? Usually you make the pad so the water runs off your pad under your hot tub, so not to deteriorate the under side of the tub. Quote Link to comment Share on other sites More sharing options...
ugotabkdin Posted October 28, 2021 Author Report Share Posted October 28, 2021 Runoff from the deck would mostly go onto the ground…just the corner of the pad would touch the deck; the sides of the pad abut bare ground. but I see your point. So should I cut the deck so there is clearance between it and the pad? Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted October 28, 2021 Report Share Posted October 28, 2021 Flat is more important than level. Match the slope and you're good. Otherwise, I'd pour over the existing to level the area. Quote Link to comment Share on other sites More sharing options...
ugotabkdin Posted October 28, 2021 Author Report Share Posted October 28, 2021 I may just avoid the whole thing and do a rock/gravel pad, a smaller hot tub, and save a bunch of $$& in the process. Quote Link to comment Share on other sites More sharing options...
broberts Posted November 2, 2021 Report Share Posted November 2, 2021 Home Depot in Canada sells a product called Top N Bond that is a special concrete for resurfacing. It ca be applied as thin as you want to feather in a patch or repair. I think you could do a patch just the size of your tub to keep pool deck water from going under the tub if that’s what you want 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.