MikeRome Posted September 22, 2021 Report Share Posted September 22, 2021 I have a barefoot b7 spa model number 95039. With a balboa control panel and vs circuit board. The tub used to shut off in between cycles now it just runs constantly on the low mode. The heater light isn’t on, I have it set to SL and F2. I lowered Temp to like 95 I checked the temp on the board(102) compared to the actual water temp (101) so it was reading correctly. The pump has gotten louder so I believe the bearing are on there way out. I hosed the filter out to make sure there wasn’t any restriction there all jets are open. Outside temp is around 70-80s here. There’s always a cover on it. Any ideas or things to try? Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted September 27, 2021 Report Share Posted September 27, 2021 What happens if you turn jets on high? Quote Link to comment Share on other sites More sharing options...
MikeRome Posted September 27, 2021 Author Report Share Posted September 27, 2021 It actually started working again today after I flipped the breaker back on. I’ve been shutting power of to it then turning it on for a few times a day then one day it began working again. When I turned the jets on high they would work. I’m pretty my pump is on its way out there this last year it’s gotten little louder Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted September 27, 2021 Report Share Posted September 27, 2021 Which does not explain the constant running. That is a control issue. But a stuck relay on the board will run non-stop, but make a loud noise if you turn it on high. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.