dgbullen Posted September 15, 2021 Report Share Posted September 15, 2021 I bought a Gecko PC Board 0201-300014 to replace my old motherboard (heater portion of my old board was fried), I have a 2008 Arctic Spa Tundra and the topside control panel is TSC-80. When I installed the new motherboard I couldn't find a jumper setting in the manual for a TSC-80, only TSC-8, which does work except there the pump 3 doesn't work. Does anyone know if there is a way to get my control panel to work properly with that board, or am I out of luck and going to have to buy a new control panel to match my new motherboard. Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted September 27, 2021 Report Share Posted September 27, 2021 @CanadianSpaTechmight know... 1 Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted September 27, 2021 Report Share Posted September 27, 2021 https://spacare.com/productimages/pdfmanuals/Gecko/MC-MP_Jumper_Settings_Programming.Pdf Try programming low level manually. I would try all jumpers at position 2. Let us know results Quote Link to comment Share on other sites More sharing options...
All Spas Services Posted October 6, 2021 Report Share Posted October 6, 2021 The Arctic Spas tsc-80 is a custom shaped tsc-8. Make sure to set your jumpers for the tsc-8 keypad Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.