Michael81 Posted July 8, 2021 Report Share Posted July 8, 2021 We have a hot tub with two pumps. Pump 1 went dead and I replaced it and noticed the other pump wasn’t doing to good. So after a few week I got both pump replaced and in the tub. The pump is wired correctly and has been tested by my local pool supply store. The problem I’m having is pump 1 has no low speed. High works and everything else works. The board comes on.. you can hear the relays clicking, in fact you can see them. But still no low speed on the pump. But again… bench test the pump works on both speeds. I’m totally at a lose. It’s a Marquis spa tub from 1997 Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted July 8, 2021 Report Share Posted July 8, 2021 Bad relay on the board. Quote Link to comment Share on other sites More sharing options...
Michael81 Posted July 14, 2021 Author Report Share Posted July 14, 2021 Nope. It was much more simple. After pulling the panel off I noticed the low speed wire on the connector on the panel had slide up. So a very simple fix… sometimes it’s the easy stuff over looked. Thank god it was a easy fix Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted July 14, 2021 Report Share Posted July 14, 2021 On 7/7/2021 at 9:21 PM, Michael81 said: pump is wired correctly and has been tested by my local pool supply store. 14 hours ago, Michael81 said: noticed the low speed wire on the connector on the panel had slide up. Only so much we can do from here. Glad you got it going. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.