IgorB Posted June 15, 2021 Report Share Posted June 15, 2021 Hey guys. I'm a newbie here, got a jacuzzi with the flat we just bought (without any manuals of course). My problem is that my circulation seems to be always running. Got a Gecko in.xm with an in.k600 control board. I was told elsewhere that it shouldn't always run (just for a couple of hours a day), and I should be able to set when the circulation is on in the Options/Filter menu, but that only sets when the blowers start up for a purge (and how many times a day). Any ideas? Thanks! Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted June 15, 2021 Report Share Posted June 15, 2021 http://www.geckoalliance.com/Documents/9919-100665.pdf Quote Link to comment Share on other sites More sharing options...
IgorB Posted June 15, 2021 Author Report Share Posted June 15, 2021 Thanks, but unfortunately I have an older version of this. Also, in this, it only tells you how to start what's called on mine the purge function, when all pumps and blowers run for a set preriod of time. Couldn't find anything on how to program the circulator... 1 hour ago, CanadianSpaTech said: http://www.geckoalliance.com/Documents/9919-100665.pdf Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted June 15, 2021 Report Share Posted June 15, 2021 Post pics of the spa equipment area so we can see what you've got in there. Not all circulation pumps are meant to turn off. In fact, I prefer a 24/7 circulation with ozone injection. Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted June 15, 2021 Report Share Posted June 15, 2021 https://www.geckodocs.com/xseries In.XM North American IN.XM-CE European Quote Link to comment Share on other sites More sharing options...
IgorB Posted June 25, 2021 Author Report Share Posted June 25, 2021 Hey guys! After some time we figured out the problem. Didn't write the full story previously cos I never considered it important, but long story short. I've had a circulation motor which stopped working, someone came and changed the motor to a new one. But as it turnes out, my old motor was designed for 24hour circulation, while the new one is not. Theoretically the in.k600 control should be able to (depending on spa setup) program purge cycles (mine was set up like this because of the 24hour circulation) or filter cycles. I guess the best solution would be to program the filter cycle, but I can't find the menu for it. I'm guessing there is some way to choose between purge or filter cycle, and it was done when the installation happened. Is there any way I can find it and set it up? is there like a master setting? thanks Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted June 25, 2021 Report Share Posted June 25, 2021 http://www.geckoalliance.com/Documents/9919-100665.pdf https://www.geckodepot.com/fichiers/documentsproduits/gda/en/qsc_xm_en.pdf 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.