trexsue Posted June 9, 2021 Report Share Posted June 9, 2021 Had the pool in service mode for tile cleaning and when it was turned back on the spa was running despite the pool indicator light being illuminated on the Aqua Logic control panel. Push the spa button and the pool filter comes on but after a few hours it reverts to the spa on its own. Any suggestions as to why this is happening? Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted June 9, 2021 Report Share Posted June 9, 2021 Perhaps the switches on the jandy valves got reversed. On the side of each valve actuator is a small 3 position switch. Switch it the opposite way that it is and see if it works right. @jimmythegreek, @Pool Clown, anything else you can think of? Quote Link to comment Share on other sites More sharing options...
trexsue Posted June 9, 2021 Author Report Share Posted June 9, 2021 Thank you. I appreciate the suggestion. Quote Link to comment Share on other sites More sharing options...
Pool Clown Posted June 11, 2021 Report Share Posted June 11, 2021 Did you have someone come in to do the tile cleaning? Did they have to lower the level of the pool? Like spa guy suggested, maybe they had not put them back to the correct orientation. 1 Quote Link to comment Share on other sites More sharing options...
trexsue Posted June 12, 2021 Author Report Share Posted June 12, 2021 Thanks for the response. I talked to my tile guy and he said he only touched the "service mode" so I'm hesitant to touch the switches. I have someone coming out to take a look next week. Could it be my board malfunctioning? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.