Andrew Smith Posted June 6, 2021 Report Share Posted June 6, 2021 Good evening, I have a 3 year old spa with a GS100 controller and a topside Balboa VL260. I switched it in on last week and something popped throwing the House RCDs. It seemed there had been water ingress into the box as a mineral staining was evident and some of the wooden frame was rotten. I fixed ingress problem and the spa heats and the pumps/ LED lights work. However i get this on the VL260 display and can't control the temperature which seems to be set at circa 40 degrees. I cant seem to find this error message in any manual. I've replaced the VL260 and get the same display on the replacement. I tested the sensors with a multimeter and they seem fine. Can anyone help? Do you think its the control panel? Regards Andrew Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted June 7, 2021 Report Share Posted June 7, 2021 That is not any error code that I have seen. Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted June 7, 2021 Report Share Posted June 7, 2021 We had a person on here not to long ago with the 6 dashes. When he posted photos of the circuit board one leg of the heater was burnt. Think he had some other issues as well and ended up getting a new board...but were not there yet. Please post photos of the circuit board and the schematic on the inside cover of the pack. 2 Quote Link to comment Share on other sites More sharing options...
Andrew Smith Posted June 7, 2021 Author Report Share Posted June 7, 2021 Please see attached. It looks all neat and tidy from this side. I'm guessing I really need to take the PCB out and look from behind? The guy in the factory did the earths up so tight you thread the screws trying to get them out. Quote Link to comment Share on other sites More sharing options...
Andrew Smith Posted June 7, 2021 Author Report Share Posted June 7, 2021 Quote Link to comment Share on other sites More sharing options...
Andrew Smith Posted June 7, 2021 Author Report Share Posted June 7, 2021 Actually just noticed where the Live comes in has melted the connection. Might this be the cause? Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted June 7, 2021 Report Share Posted June 7, 2021 Whether it is or not it will require repair... and yes it is likely the cause. 1 1 Quote Link to comment Share on other sites More sharing options...
Andrew Smith Posted June 7, 2021 Author Report Share Posted June 7, 2021 Thanks! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.