Salspa Posted May 29, 2021 Report Share Posted May 29, 2021 Help please! I have a Balboa GS100 spa that I’m wanting to heat, but I cannot get the pump/heater to stay on longer than 30 minutes. IE every 30 mins I have to go out and turn it on, so it takes days to get hot! Is this right? Do I need to run full jets to warm, or just the pump? Is there anyway to extend time period on pump? I have set jets to maximum on the control panel on the motor. Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted May 29, 2021 Report Share Posted May 29, 2021 Check what mode you are in and verify it is in "Standard" mode and not economy or sleep mode. Also verify you have your filter cycle set at F2 = 2 hours out of 12 hour period or 4 hours out of 24 total. 2 hours in the am and 2 hours in the pm. Clean filters weekly https://irp-cdn.multiscreensite.com/f88b8dc9/files/uploaded/Plug %26 Play Topside.pdf Quote Link to comment Share on other sites More sharing options...
Salspa Posted May 29, 2021 Author Report Share Posted May 29, 2021 Thank you @CanadianSpaTech- it is set to St, and I think I saw F5 (but will check in the morning - late night here in Aus). Still won’t stay on for more than half an hour - pump or jets. What am I doing wrong? 😔 Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted May 29, 2021 Report Share Posted May 29, 2021 Post photos of the circuit board and schematic on the inside cover 1 Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted May 29, 2021 Report Share Posted May 29, 2021 Does it run in both speeds as it should, or just in high speed? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.