Jump to content

Recommended Posts

I have a DreamMaker Galaxy spa that cycles through the circulating cycle and temp only gets up to 95 degrees. When i push jets button on control panel the jets don't come on. Just put a new control panel in hoping that was the issue but it wasn't. Any ideas?



Link to post
Share on other sites

Post a picture of the circuit board, wiring diagram, and equipment area.

Are there any errors on the display? 

Have you checked the mode and filter cycle duration?

Do you have a multimeter?

  • Like 1
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...