Deereone Posted April 8, 2021 Report Share Posted April 8, 2021 Installed new heating element,new filter ,water flow seems normal.Control board working normal.Normally will heat up in 4-5 hours.Now can't et above 54 degrees .What can I do next? Quote Link to comment Share on other sites More sharing options...
Cusser Posted April 8, 2021 Report Share Posted April 8, 2021 I'd check that the heating element is actually getting voltage. Did you measure ohms resistance of the new heating element before you installed it? Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted April 8, 2021 Report Share Posted April 8, 2021 What brand?? Are there any errors? Post a picture if equipment area and circuit board. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.