Jump to content

Jandy JXi Heater Slow Temp Rise


Recommended Posts

Before the freeze in Texas a few weeks ago, I "winterized" my pool equipment by removing the filter, pump, and heater "plugs" and drained the system. After the freeze, I replaced the plugs, primed the pump and started up the system. Everything works, except the Jandy JXi gas fired heater took 4 hours to heat the spa section of the pool from 68 degrees to 104. The heater never cycled on and off; it ran continuously until the temp was reached, and then it shut off. Before the freeze, the spa heated to 104 in 30-40 min. What could the issue be, and how do I fix it?
Show less
 
 
 
 
Link to post
Share on other sites

Double check that you valves are activating properly. This issue usually is a result of either the powered valves or a manual valve not keeping the spa isolated. If that is 100% not the issue then likely a gas issue whether pressure or low flame output

  • Like 1
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...