DanXman Posted February 8, 2021 Report Share Posted February 8, 2021 Looking for any insight into what my issues are. Nothing seems to work other than the display on the controller. I am getting the double -.-.-.- lines on the display after trying to turn on the jets. Pumps aren't turning on, heater doesn't seem to be as well. Yes, newbie here but trying to figure out what could be the issue. Bled air out of the junctions so no air locks. Could the pressure sensor cause everything to not work? In the electrical panel, there are a couple click noises. There is a red light that comes on next to the D17 on the circuit board. thanks in advance for any insight or suggestions on how to trouble shoot. If there is another thread that I should be looking at to run through some common issues, please let me know. thanks in advance! Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted February 8, 2021 Report Share Posted February 8, 2021 Page 27: https://www.pioneerfamilypools.ca/wp-content/uploads/resources/hottub-info/4howto/Hot-Tub-Troubleshooting-Guide.pdf 1 Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted February 9, 2021 Report Share Posted February 9, 2021 Remove your filter. Check for flow and lots of bubbles from heat return. Post pic of circuit board. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.