r5ran Posted October 4, 2020 Report Share Posted October 4, 2020 Hi, Been a while since I posted here, but was wondering if, on a 2008 HS Vanguard, you can swap the connectors between pump motor 1 and 2? I am having no problems, but when you hit the clean button, it runs motor 1 for a few minutes. Motor 1 runs the neck jets of the two corner seats, and if the water is a bit low, it can send a big spray across the top of the water. Swapping these connectors would now run pump 2 when you hit the clean button instead, which has all of it's jets much lower in the water. I will be away for awhile and I'm having a neighbor check my tub periodically, and I'm just trying to not get her sprayed! From the schematics, it looks like it should be fine, but just checking if anyone has done this first. I realize that now the operation of the jet 1 and 2 buttons will be swapped, too. Thank you, Randy Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted October 5, 2020 Report Share Posted October 5, 2020 Good question. 🤔 Let us know how it goes. The only potential issue I see is if pump 2 is unfiltered, which I am not sure on that tub. Quote Link to comment Share on other sites More sharing options...
r5ran Posted October 8, 2020 Author Report Share Posted October 8, 2020 Just an update, I swapped the motor connections, and as I suspected, (and hoped) all worked fine. FYI - Hot Springs do not use a bypass valve (hence the 5 filters) so neither pump is unfiltered. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.