RoadieJune Posted August 18, 2020 Report Share Posted August 18, 2020 We have a high pH level and have attempted to adjust the sanitizer output. The output level is stuck at 60% I have attempted to adjust the output by pushing the less button. It will go to 40% but will not go any lower. And then it returns to 60%I have also attempted to make adjustments to the Easytouch control system panel. I followed the instruction booklet and disabled the Intellichlor unit on the panel. However, no change was made, on the slide panel. If I turn off power to the Intellichlor unit at the pentair power box it will also shut off the pool pump. What is your advice? Quote Link to comment Share on other sites More sharing options...
rspar Posted August 20, 2020 Report Share Posted August 20, 2020 I wouldn't call myself a salt system expert but it sounds like you need to clean the cell. High pH is a killer for salt cells which is ironic since they tend to raise the pH. 1 Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted August 22, 2020 Report Share Posted August 22, 2020 Frequent cleaning with acid solution is a must. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.