Joe5150 Posted July 29, 2020 Report Share Posted July 29, 2020 (edited) Ok ... I have 15 year old tub . I decided to replace the balboa 1500 controller/ heater and replaced the pump / motor . Reason why? The old controller shorted out and I want to keep the tub for a few more years. After the new parts went in the motor ( 2 speed 240v ) keeps cycling on and off . Like 2 seconds each time for about 20 times until the thermal overload kicks the motor off . Did my top controller go bad ? I do have 240v going out 🤔but it doesn’t run like it .. or sound like it’s pumping at 240v ... any direction? FullSizeRender.mov Edited July 29, 2020 by Joe5150 Video too big Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted July 30, 2020 Report Share Posted July 30, 2020 Post some pics of the circuit board, controller, and pump spec label. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.