SunnyDayz Posted May 19, 2020 Report Share Posted May 19, 2020 Hi everyone, I have the below Jandy AquaPure Saltwater cell that is stuck in "cell reversing". A local service company replaced the cell and the "Zodiac R0467600 Printed Circuit Board Power Interface" last season. I have cleaned the cell but I am still getting the cell reversing. Does anyone have any suggestions? Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted May 19, 2020 Report Share Posted May 19, 2020 Have you read this? https://www.google.com/url?sa=t&source=web&rct=j&url=https://www.poolspaforum.com/forum/index.php%3F/topic/20276-no-flow-and-cell-reversing-on-jandy-aquapure-1400/&ved=2ahUKEwiw07Pfq8DpAhUEAZ0JHcppBhkQFjACegQIARAB&usg=AOvVaw19NnJwOWxFwLMgjxDImgSk Quote Link to comment Share on other sites More sharing options...
PatBa Posted July 16, 2021 Report Share Posted July 16, 2021 Mine does the same, stuck in cell reversing, DOES show flow, and voltage to cell is -23-30 VDC (negative). Error codes 125/194. My sensor appears to be working based on temperature and salt additions (salinity increase follows calculated increase based on salt additions). I cleaned my cell (no foam or bubbles) without any change. I saw in the AquaPure workbook a failure referred to as "Coating worn off of plates." My cell is old but only runs a few months a year. Could it be the cell is dead due to the low voltage codes? The story above is the same as mine except I do not have a new cell. Finally, I am making some small amount of chlorine - is that happening in "reverse" ?? Thanks in advance. Quote Link to comment Share on other sites More sharing options...
Eddie Day Posted July 11, 2022 Report Share Posted July 11, 2022 Did you ever figure this out? Quote Link to comment Share on other sites More sharing options...
Eddie Day Posted July 11, 2022 Report Share Posted July 11, 2022 Did you ever figure out this problem? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.