dunja Posted April 19, 2020 Report Share Posted April 19, 2020 Hi all, last winter i drained my jacuzzi because the powercosts in The Netherlands are too high (and getting higher). now last week i cleaned my pool and filled it with water again, only problem is it's not heating anymore (also no sound that it starts too warm up) i had the same problem last year only then i put a high pressure spray on the massagers to drain the tubes, it was a lot of work, but there was a lot of "waste" coming out the Balboa display says: "dr" & also "sns" and also from the waterfall there doesnt come any water out (on the photo above, the small sleeve) i put the waterhose in the part where normally the filter is, so the water comes out at the bottom, the water still comes out at the bottom, but also the part where the filter is gets full, and the water also goes out there hope someone has an idea Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted April 19, 2020 Report Share Posted April 19, 2020 Test circulation pump. If waterfall not working likely the circ pump is not running Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted April 19, 2020 Report Share Posted April 19, 2020 Did you fill it through the filter well? You may just have a airlock. Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted April 19, 2020 Report Share Posted April 19, 2020 or that Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.