andy thorn Posted October 8, 2018 Report Share Posted October 8, 2018 hi I am new to the hot tub scene and have just bought a 2004? coast nassau hot tub, ( needing a little work ) my current problem is the 3 dots on top side panel, red led on printed circuit and not being able to clear the air in the lines, I have changed the pressure switch ( the 3 dot go off when I switch to 2nd speed) the temp is set to 100f but is maintaining about 82f ( it has got to 100 previously) the heater tube is only normal temp not boiling i keep releasing the air from the filter bleed screw but within minutes its back again ( i do have about 10 out of 40 jet missing at the moment - waiting for replacements) any suggestions, or is it due to missing jet sucking the air back into the lines and then causing the low flow? thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.