rrobinson Posted April 10, 2018 Report Share Posted April 10, 2018 I have a 1998 Hot Springs Classic Model F. The light bulb does not light up. Control panel buttons work and the display shows that the light should be on. I tested the board (IQ2000) and there is no power where the light plugs into the board. Is there anything I can do or does this just mean that this part of the board is bad? Quote Link to comment Share on other sites More sharing options...
Jersey Hot Tub Repair Posted April 10, 2018 Report Share Posted April 10, 2018 Are the spade connectors on the circuit board clean? I'd try cleaning them off with some fine grit emery sandpaper, just to make sure you are getting a good electrical contact. Dave Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.