Jump to content

New 52518 Balboa board


Eddieba

Recommended Posts

Old Morgan Spa
 
I replaced the 50745 board with a new M3 retro fit 52518 board along with a new topside controller-51058.
 
I have 2 motors- 2 speed motors
1- blower
No ozonator
 
1.  On the new board I pulled the J10 jumper
2. J7 is on "A" side
3. J25 is on 60Hz
 
There is a flashing FLO code along with COOL. I have tested the continuity of the pressure switch while the pumps are on and it is closed and open when the pumps are off.
 
Pump 1 is running on low speed and high speed when press pump 1. When pressed third time the 2nd pump does not turn on.  The 2nd pump does not come on at all now. The old board does not have a relay on pump 2 if this matters.
 
When press clock(time)- blower comes on????
 
Press blower button-(bottom right) something clicks on board but blower does not turn on.
 
I feel I am missing something.  Any suggestions? 
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...