Hughescorp Posted August 22, 2017 Report Share Posted August 22, 2017 My salt sensor has always read a little higher than tested. (approx 400-500 over the tested value). no problem, just added extra salt when needed. Just this weekend my sensor went from reading 3200-3400 to 25500. I cleaned the sensor with a soft dish scrubber (no obvious visible scale at first glance). still reading 25500. Any suggestions? Quote Link to comment Share on other sites More sharing options...
Pool Clown Posted August 29, 2017 Report Share Posted August 29, 2017 Unfortunately, the sensor is bad, and needs to be replaced. Hopefully, you are still under warranty Quote Link to comment Share on other sites More sharing options...
Sandi and Dennis Posted September 23, 2017 Report Share Posted September 23, 2017 We replaced our sensor today and it was slightly different. Added an interface module that plugged right in... but there is no power to that module or the Aquapure interface, which was not an occur before. We had a constant no flow message from the old sensor. Any suggestions? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.