Jump to content
Hughescorp

Jandy 1400 aqua pure issues

Recommended Posts

My salt sensor has always read a little higher than tested. (approx 400-500 over the tested value).  no problem, just added extra salt when needed.  Just this weekend my sensor went from reading 3200-3400 to 25500.  I cleaned the sensor with a soft dish scrubber (no obvious visible scale at first glance). still reading 25500.  Any suggestions?

Share this post


Link to post
Share on other sites

Unfortunately, the sensor is bad, and needs to be replaced.  Hopefully, you are still under warranty

Share this post


Link to post
Share on other sites

We replaced our sensor today and it was slightly different. Added an interface module that plugged right in... but there is no power to that module or the Aquapure interface,  which was not an occur before. We had a constant no flow message from the old sensor. Any suggestions?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Get a Free Hot Tub Quote

Save time and money by receiving multiple, independent quotes for a hot tub.



×