Scooby Posted August 15, 2017 Report Share Posted August 15, 2017 I have a 2004 model SS Vista Hot Springs spa. I disconnected my tub and gave it to a friend. When we reinstalled it at his house the pump breaker kept tripping. This is a 2 pole 30A GFI breaker. I tested the breaker and conductors to make sure they were good and they are. When I removed a wire from the terminal board, in this case terminal 2, the breaker reset. Does this mean I need to change the whole board? I've noticed on line, a few stores sell a heater relay board which looks a lot like the board I am questioning. Is this the correct item to change? What else should I check? I've disconnected both pumps at the board to make sure there is no load on the board but the breaker still trips so I know it is not tripping due to a bad motor. Any suggestions would be greatly appreciated. Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.