whfh99 Posted September 15, 2016 Report Share Posted September 15, 2016 I just filled my Hot Springs Sovereign tub after having drained it for the summer and it's wired for 230V so I just put on the 110V breaker, filled it through the middle filter so the circulator pump started fine, worked out the bubbles and is running well. However, the red power light is flashing and this is before I even turned on the 230V for the heater so it's not like it overheated. The main jet pump will not work with the red flashing power light. There is no button for a hi limit switch or anything to 'reset' on my control box. What else should I check? It was working fine in May when I shut it down. Thanks in advance. Quote Link to comment Share on other sites More sharing options...
whfh99 Posted September 27, 2018 Author Report Share Posted September 27, 2018 This just happened to me again this season. Same hot tub. I cannot recall what the fix was. I seem to think the issue was that the water I filled it with may have been too cold? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.