Warehousebroker Posted January 1, 2016 Report Share Posted January 1, 2016 Recently acquired my parents Hotspring Sovereign 2003 model. Had to replace heater relay board and small circulation pump. Panel lights operating as they shoukd now, spa is properly primed from what I can tell, ozone with bubbles working as they should. Now when I turned on heater breaker, set temp to 102, after about 5 minutes the breaker trips. I feel the water warm where the bubbles rise so it seems to be heating. Heater is Watkins no fault 6000. Any suggestions or advice would be helpful. Quote Link to comment Share on other sites More sharing options...
PreservedSwine Posted January 4, 2016 Report Share Posted January 4, 2016 Likely a bad heater, or bad breaker. Quote Link to comment Share on other sites More sharing options...
Warehousebroker Posted January 6, 2016 Author Report Share Posted January 6, 2016 The electrician re-wired it back to 115v and it has been working just fine. Do you think that the breaker is bad and couldn't handle the load? He didn't have a different breaker with him to switch it out and test it at the time. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.